Fluke Ethernet Tester Repair

$245.00

Full-service Fluke Ethernet Tester repair: diagnostics, component replacement, and recalibration. We address battery compartment corrosion and other common ethernet tester faults. Nationwide service — ship from anywhere in the US.

Description

Fluke Ethernet / Cable Tester Repair and Calibration

Fluke Networks Ethernet and cable testers — handheld instruments that verify, qualify, and certify copper and fiber network cabling and confirm Ethernet connectivity for installers and IT teams. Whatever the model, faults concentrate in the test ports/adapters, the measurement engine, and the battery.

FlukeMeterRepair.com repairs and calibrates Fluke Networks Ethernet and cable testers for network installers, IT technicians, and low-voltage contractors. Tell us your exact model and the symptom and we’ll advise on turnaround and cost.

Models we commonly service

Certifiers: DSX-series, DTX-series, DSP-series, OmniScanner
Qualifiers/verifiers: LinkIQ, CableIQ, MicroScanner
Connectivity: LinkRunner (LRAT) series, OneTouch

Common problems we fix

Battery-compartment corrosion — cleaned, repaired, and contacts restored
Test-port / adapter faults — a worn or damaged port or adapter degrading results, repaired or replaced
Measurement / certification faults — readings out of spec, recalibrated against standards
Touchscreen, connectivity, or battery faults — repaired

FAQs

Which Fluke ethernet / cable tester do you repair? Most models — send us the model number and the fault and we’ll confirm. Every repair includes calibration verification and a 90-day parts-and-labor warranty.

What should I send? The instrument and any model-specific accessories involved in the fault; we’ll let you know if a paired or remote unit is needed.

Email us or request service.